Applying transform to files in project
I'm using the project view to apply a transform to many files. The resulting files can be large and also include MathML. I'm finding that after processing say 10-15 files, Oxygen reports out of memory and starts to seize up. I notice that the result files are being loaded in the message area, which may be part of the cause. Is this expected behavior? I would have expected the conversion to happen but not to take up more memory than is required for a single transform instance. Cheers, E. -- Eliot Kimber Senior Solutions Architect "Bringing Strategy, Content, and Technology Together" Main: 512.554.9368 www.reallysi.com www.rsuitecms.com
Hello Eliot, You are correct in suspecting the results from the message area(results panel). To disable these and minimize the memory use during a transformation, edit the transformation scenario(Document -> Transformation -> Configure Transformation, Edit) and in the Output tab remove all the options from the "Show as" section(bottom): XHTML, XML, SVG Let us know if the problem persists. Regards, Adrian Adrian Buza oXygen XML Editor and Author Support Tel: +1-650-352-1250 ext.202 Fax: +40-251-461482 support@oxygenxml.com http://www.oxygenxml.com Eliot Kimber wrote:
I'm using the project view to apply a transform to many files. The resulting files can be large and also include MathML.
I'm finding that after processing say 10-15 files, Oxygen reports out of memory and starts to seize up.
I notice that the result files are being loaded in the message area, which may be part of the cause.
Is this expected behavior? I would have expected the conversion to happen but not to take up more memory than is required for a single transform instance.
Cheers,
E.
Ah, didn't realize the "Show as" was what puts the files in the message area. Cheers, E. On 1/31/12 8:28 AM, "Adrian Buza" <adrian@sync.ro> wrote:
Hello Eliot,
You are correct in suspecting the results from the message area(results panel). To disable these and minimize the memory use during a transformation, edit the transformation scenario(Document -> Transformation -> Configure Transformation, Edit) and in the Output tab remove all the options from the "Show as" section(bottom): XHTML, XML, SVG
Let us know if the problem persists.
Regards, Adrian
Adrian Buza oXygen XML Editor and Author Support
Tel: +1-650-352-1250 ext.202 Fax: +40-251-461482 support@oxygenxml.com http://www.oxygenxml.com
Eliot Kimber wrote:
I'm using the project view to apply a transform to many files. The resulting files can be large and also include MathML.
I'm finding that after processing say 10-15 files, Oxygen reports out of memory and starts to seize up.
I notice that the result files are being loaded in the message area, which may be part of the cause.
Is this expected behavior? I would have expected the conversion to happen but not to take up more memory than is required for a single transform instance.
Cheers,
E.
-- Eliot Kimber Senior Solutions Architect "Bringing Strategy, Content, and Technology Together" Main: 512.554.9368 www.reallysi.com www.rsuitecms.com
participants (2)
-
Adrian Buza -
Eliot Kimber